www.texas.dk
20
12. Spark plug
13. Maintenance and storage
Every time the machine has been used it should be cleaned completely.
If the machine will not be used for a longer period of time the fuel tank must be emptied
completely. All metal parts must be oiled to prevent corrosion.
Remove the spark plug, pour a few drops of engine oil into the cylinder and pull the star-
ting cord 2-3 times to make the oil disperse. Fit the spark plug.
Only use original spare parts.
Check the spark plug after 10-15 hours of use.
Remove the spark plug cap. Use the spark plug wrench to re-
move the spark plug.
Clean the spark plug and adjust the spark plug gap to 0.6 - 0.7
mm.
Replace damaged or worn spark plugs.
Fit the spark plug with your fingers. Fasten tightly using the
wrench.
Use spark plugs type Denso W14M-U10.
To Next Page
Loading...
