To Next PageTo Next Page
Need help?Do you have a question about the Texas TG595 and is the answer not in the manual?
Check engine oil level in horizontal position without fastening oil stick.
Change oil according to manual. Heat, drain, replace screw, and add new oil.
Pump primer, activate clutch, pull starter cord slowly to resistance, then pull firmly.
Release the handle/engine brake lever to turn off the engine.
Monitor exhaust, listen for noises. Turn off and adjust if issues arise.
Clean, inspect, measure gap (0.7-0.8mm), replace if needed.
Place engine horizontally to prevent fuel and oil spillage during transport.
Add oil, pull cord, protect with oil, store dust-free and out of children's reach.
General
