Texecom PREMIER 88 - Overview of Texecom Premier Series Alarm System; System Basics and Components

Factory Defaults Premier 48, 88 & 168 Factory Defaults and Quick Reference Guide
4 INS222
Menu Option Default
7. UDL/Digi Options Continued
Setup Modules
Setup Radio-Pad ARC 1 Pri. No. Not Defined
ARC 1 Sec. No. Not Defined
ARC 1 Prefix Not Defined
ARC 2 Pri. No. Not Defined
ARC 2 Sec. No. Not Defined
ARC 2 Prefix Not Defined
ARC 3 Pri. No. Not Defined
ARC 3 Sec. No. Not Defined
ARC 3 Prefix Not Defined
Radio Pad Attempt 03
Setup AV Module? AV No.1> Not Defined
AV No. 2> Not Defined
AV No. 2> Not Defined
AV Dial Attempts 03
AV Re-Dial Delay 30 Minutes
Setup IP Data? ComIP Address Not Defined
ComIP Port 10001
ComIP Gateway Not Defined
Subnet Mask 255.255.255.0
Polling Address Not Defined
ComIP Name Not Defined
SMS Centre Pri. 07860980480
SMS Centre Sec. Not Defined
Modem Setup Stg. Not Defined
Modem Speed 2400
Com Port Setup Onboard Digi Com300
Com 1 No Module Fitted
Com 2 No Module Fitted
Expansion Port No Module Fitted
8. User Codes
Setup Users User 00 (Engineer) 1234
User 01 (Master) 5678 ****
All other Users Not Defined ****
* This options can alter the Programming as defined
below.
** These options are enabled/disabled when Config.
Option 37 is programmed as ‘Grade 2’.
*** These outputs will default to the same as the Com
Channels when Config. Option 37 is programmed as
‘Grade 2’. (see Note below)
**** All users except the engineer are defaulted to lock out
during entry.
"
To quickly change the programming for the ‘Digi
Outputs’ between Grade 2 and Grade 3 without
having to manually program each output, go to
‘System Config.’ Which is in the ‘System Options’
menu and select the required Grade (option 37), then
go to ‘Default NVM’ which is in the ‘Engineer Utils’
menu, select ‘Digi Outputs’ and then press ‘YES’ to
default them.
This will only default the Digi Outputs on the control
panel, no other programming will change.