4
Important Safety Information
Electric shock hazard:
Do not expose this unit to rain or moisture.•
Use this unit for the manufacturer’s intended purpose only, as described in •
this manual. Any other use can impair the protection provided by the unit.
Use test leads or accessories that are appropriate for the application. Refer to •
the category and voltage rating of the test lead or accessory.
Inspect the test leads or accessory before use. They must be clean and dry, •
and the insulation must be in good condition.
Before removing the case or battery cover, remove the test leads from the •
circuit and shut off the unit.
Failure to observe these warnings could result in severe injury or death.
Electric shock hazard:
Do not connect transmitter to any active AC circuits over 120 VAC.
Failure to observe this precaution may result in injury and can damage the
instrument.
Electric shock hazard:
Do not attempt to repair this unit. It contains no user-serviceable parts.
Failure to observe this precaution may result in injury and can damage the
instrument.
To Next Page
Loading...
Need help?
General
