45
5. Remove the reverse light housing by
removing the two screws and nut;
then remove the two machine
screws. Rotate the bulb counter-
clockwise to remove from socket.
PK065A
PK066
6. To install the taillight/brakelight,
insert the bulb into the socket and
turn clockwise. Insert the socket into
the taillight assembly and turn
clockwise.
7. To install the reverse light, insert the
bulb into the socket and turn clock-
wise. Insert the socket into the
reverse light housing and secure
with the two machine screws.
8. Secure the reverse light housing into
the taillight assembly with the two
screws and nut.
9. Place the rear fender onto the cargo
box and secure with the six plastic
screws. Secure the tie-down with the
two nuts and cap screws.
10. Connect the taillight/brakelight con-
nector.
Checking/Adjusting
Headlight Aim
The headlights can be adjusted vertically.
The geometric center of the HIGH beam
light zone is to be used for aiming.
1. Position the vehicle on a level floor
so the headlights are approximately
6.1 m (20 ft) from an aiming surface
(wall or similar aiming surface).
0748-733
NOTE: There should be an average
operating load on the vehicle when
adjusting the headlight aim.
2. Measure the distance from the floor
to the mid-point of each headlight.
3. Using the measurements obtained in
step 2, make horizontal marks on the
aiming surface.
4. Make vertical marks which intersect
the horizontal marks on the aiming
surface directly in front of the head-
lights.
5. Switch on the lights. Make sure the
HIGH beam is on. DO NOT USE
LOW BEAM.
6. Observe each headlight beam aim.
Proper aim is when the most intense
beam is centered on the vertical
mark 5 cm (2 in.) below the horizon-
tal mark on the aiming surface.
7. Loosen the headlight adjustment
screw; then adjust the headlight up
or down as required. Tighten the
headlight adjustment screw.
PK081A
To Next Page
Loading...
