EasyManua.ls Logo

TEXWRAP 2219 Series User Manual

TEXWRAP 2219 Series
71 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Confidential and Proprietary 2.3
Rev. 10.06
Texwrap
“Built-Better/Backed-Better Warranty
All Texwrap manufactured components are warranted against defects in design, material and
workmanship for a period of three (3) years- unlimited cycles. All purchased components are
warranted for a period of one year. Warranty is transferrable for the life of the Warranty
beginning with date of shipment to the original purchaser's facility. Warranty does not cover
the replacement of consumable/wear items (sealing blades, sealing pads, tape, belts, etc),
routine maintenance, or alignments.
Texwrap will, at their discretion, repair or replace a defective component at no charge
including UPS ground transportation. Field technician labor is typically handled on
warranted items by local Texwrap distributors on a billable basis. Contact your local
Texwrap distributor for their warranty claim procedure and policies.
This warranty will become null and void if it is determined by Texwrap that:
- the equipment is misused, abused or neglected in any way.
- the equipment is altered or modified without prior written approval from Texwrap.
Texwrap does not warrant that the equipment conforms to any insurance regulation, electrical
or safety code (with the exception of panels containing UL stickers, which meet UL codes).
The purchaser assumes liability for compliance with all applicable statutes, codes and
regulations whether federal, state or local.
This limited warranty applies only to the repair or replacement of defective parts. Warranty
does not cover replacement parts not purchased from Texwrap.
For any replacement part shipped under warranty, the defective part must be returned to
Texwrap by a Texwrap distributor within 30 days for examination. If determined to be
defective, a credit will be issued. If the part is determined not to be defective, the part will be
returned to shipper and no credit issued. Credits will not be issued for parts after 30 days.
Please note: A Return Authorization (RA) number must be obtained from the Parts
Department prior to shipment of a defective part to Texwrap.
Question and Answer IconNeed help?

Do you have a question about the TEXWRAP 2219 Series and is the answer not in the manual?

TEXWRAP 2219 Series Specifications

General IconGeneral
BrandTEXWRAP
Model2219 Series
CategoryFood Saver
LanguageEnglish

Summary

INSTALLATION REQUIREMENTS

MACHINE SET-UP PROCEDURE

Outlines the sequence of actions to assemble and prepare the machine for operation.

FILM ROUTING

SCRAP ROUTING

Machine Interface

TOUCH PAD PANEL QUICK ACCESS BUTTONS

HOME SCREEN

Front and Rear Bag Settings

User Levels

Heater Settings

Seal Time

Details the duration the seal bar remains in contact with the lower seal pad for a good seal.

Motion Trims

Scrap Alarm

Seal Compensation

Service

Tune Heaters

Calibrates the cross and side seal heaters for optimal performance.

PLC Inputs / Outputs

PROGRAM LIBRARY

Saving Machine Setups

Loading Machine Setups

Deleting Machine Setups

ERROR SCREENS & SOLUTIONS

Common Error Causes

Lists common error messages and their potential causes and corrective actions.

Recommended Maintenance Schedule

CONVEYOR BELT TRACKING

Film Clamp Safety

Adjusting the Film Clamp Safety Switches