1312
Digital bath thermometer
• Unauthorized repairs, alterations or changes to the product are
prohibited.
• Do not use the device if it seems to be damaged.
Caution!
Risk of injury:
• Always check the water temperature with the back of your hand
before putting a child into a bath.
• The product is not a toy. Use under parental supervision.
• Keep this device and the batteries out of reach of children.
• Batteries contain harmful acids and may be hazardous if swal-
lowed. If a battery is swallowed, this can lead to serious inter-
nal burns and death within two hours. If you suspect a battery
could have been swallowed or otherwise caught in the body,
seek medical help immediately.
• Batteries must not be thrown into a fire, short-circuited, taken
apart or recharged. Risk of explosion!
• Low batteries should be changed as soon as possible to pre-
vent damage caused by leaking.
• Never use a combination of old and new batteries together, nor
batteries of different types.
• Avoid contact with skin, eyes and mucous membranes when
handling leaking batteries. In case of contact, immediately rinse
the affected areas with water and consult a doctor.
Important information on product safety!
• Do not expose the device to extreme temperatures, vibrations
or shocks.
Digital bath thermometer
5. Elements
A: Display
A 1: Temperature display °C/°F
A 2: Temperature alarm HOT/COOL
B: Buttons
B 1: ON/SET button B 2: + button
B 3: °C/°F button
C: Housing
C 1: LED signal light C 2: Battery compartment
C 3: Temperature probe C 4: Release button
6. Getting started
• Place the duck in the water or press any button.
• The temperature appears on the display.
• The device will turn off automatically after approx. 30 minutes.
7. Temperature alarm
• Press and hold the ON/SET button for 2 seconds. 39 °C
(default) appears on the display and HOT flashes. You can
choose the upper temperature limit (37 °C, 38 °C, 39 °C or
40 °C) with the + button.
• Confirm the setting with the ON/SET button.
• The lower temperature limit is factory set to 30 °C.
• If the water temperature rises above the set upper temperature
limit, HOT appears on the display and the LED signal light
flashes red.
• If the water temperature drops below 30 °C, COOL appears on
the display and the LED signal light flashes green.
TFA_No. 30.2031_Anleit_05_24 24.05.2024 8:59 Uhr Seite 7
To Next Page
Loading...
