TFA 30.3016.01.IT - Battery Installation Procedure

38
1. Remove the battery compartment cover at the back of the transmitter.
2. Insert the batteries, observing the correct polarity (see marking).
3. Replace the battery compartment cover on the unit.
INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE STATION
The temperature station uses 2 x AA, IEC LR6, 1.5V batteries. To
install and replace the batteries, please follow the steps below:
1. Remove the cover at the back of the temperature station.
2. Insert batteries observing the correct polarity (see marking).
3. Replace compartment cover.