TFA 60.2550 - Page 15

2928
Radio-controlled alarm clock

Radio-controlled alarm clock

• The first alarm time is now activated.
• When the adjusted alarm time is reached, the alarm will ring.
• The alarm symbol will be flashing and the backlight will be activated
for 5 seconds.
• Press any button to stop the alarm.
• If the alarm is not stopped manually, the alarm will automatically
turn off after a few minutes.
• The alarm symbol remains on the display and the alarm time will be
reactivated at the same time
• When the alarm rings, press the SNOOZE/LIGHT button to activate the
snooze function.
• Once the snooze function is activated, zZ will be flashing on the dis-
play.
• The alarm will be interrupted for 5 minutes.
• Slide the alarm time 1 ON/OFF switch downwards (OFF) to deacti-
vate the alarm function.
• The alarm symbol and the colour mark disappear.
8.2 Setting of the second alarm time
• Press the button in normal mode.
• 7:00 (default), or the last adjusted alarm time, appears on the dis-
play.
7.1.3 Setting of the button tone
• Normally, the button tone (beep) is disabled (OFF).
• Press the – or + button to activate the button tone (ON).
• Confirm the setting with the SET button.
8. Alarm
• The alarm clock has two separate alarms with different alarm tones.
8.1 Setting of the first alarm time
• Press the button in normal mode.
• 7:00 (default) or the last adjusted alarm time, appears on the display.
• The hour digits flash.
• Press the – or + button to adjust the hours.
• Confirm the setting with the button.
• The minute digits will be flashing. Press the – or + button to adjust
the minutes.
• Confirm the setting with the button.
• The adjusted alarm time appears on the display.
• To activate the alarm function, move the switch alarm time 1 ON/OFF
upwards (ON). At the same time, the box is highlighted in colour and
a frame with the alarm symbol appears around the alarm time:
TFA_No. 60.2550_Anleitung_02_23 21.02.2023 15:04 Uhr Seite 15