Radio-controlled projection clock with thermometer
Radio-controlled projection clock with thermometer
1716
7.6 Dual time setting
• Press the MODEbutton three times in the normal mode.
• DUAL TIME and 0:00 appear on the display.
• Hold the MODE button for 2 seconds. The hour digits are flashing.
• Press the – or + button to adjust the time.
• Confirm with the MODE button and set minutes in the same way.
• Confirm with the MODE button.
8. Projection and backlight
A. Without continued projection (CONTINUE PROJECTION off)
• Press the LIGHT/SNOOZE button. The backlight and the projec-
tion w ill light for a few seconds.
B. For permanent projection plug in the adapter and turn on the
CONTINUE PROJECTION switch upwards.
9. Care and maintenance
• Clean it with a soft damp cloth. Do not use solvents or scouring
agents. Protect from moisture.
• Remove the batteries and pull out the plug of the socket, if you do
not use the product for a lengthy period.
• Keep the instrument in a dry place.
9.1 Battery replacement
• Replace the batteries when the display becomes weak.
• Insert two new batteries 1,5 V AAA into the battery compartment,
observing the correct polarity.
10. Troubleshooting
Problems Solution
No indication ➜ Connect unit to mains adapter
➜ Ensure batteries polarity are correct
➜ Change batteries
No DCF reception ➜ Press and hold WAVE/°C/°F button
for two seconds to activate the
reception
➜ Choose another place for the
instrument
➜ Manual setting of the clock
➜ Wait for attempted reception during
the night
➜ Check if there is any source of
interference
7.2 Day-of-week language
• Press and hold the – button to choose the language for the weekday.
• Language abbreviations change from one language to another: Eng-
lish (EN), German (GE), Italian (IT), French (FR) and Spanish (SP).
7.3 Temperature display
• Press the WAVE / °C/°F button to change between °C (Celsius) or °F
(Fahrenheit) as temperature unit.
7.4 Setting of time zone
• The time zone is used for countries where the DCF signal can be
received but the time zone is different from the DCF time (e.g.
+1=one hour later).
• Press and hold the + button for 2 seconds in normal mode
(time/temperature display).
• “F” appears on the display.
• Press and hold the MODE button for 2 seconds.
• The hour digit is flashing. Press the – or + button to adjust hours to
your local time.
• Confirm with the MODE button.
• Press and hold the + button for 2 seconds to return to normal mode.
7.5 Alarm setting
• Select your desired alarm by the MODE button:
Alarm 1
Alarm 2
• Set the alarm time in the desired alarm mode.
• Press and hold the MODE button and the hour digits are flashing.
• Press the – or + button to adjust the time.
• Confirm with the MODE button. Set minutes in the same way.
• Confirm with the MODE button and the alarm is activated.
• appears on the display.
• If necessary adjust the second alarm time in the same way.
• To activate or deactivate the alarm function press the ALARM button.
, , + or no alarm symbol is shown on the LCD.
• Once the alarm starts to ring, you can stop the alarm by pressing
the ALARM button.
• You can activate the snooze function by pressing the LIGHT/SNOOZE
button on the top.
• Zz appears and the alarm will be interrupted for 4 minutes.
TFA_No. 60.5002_Anleitung_09_16 29.09.2016 16:03 Uhr Seite 9
To Next Page
Loading...
