EasyManua.ls Logo

TFA ScanTemp 410 - Page 6

TFA ScanTemp 410
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
Infrared Thermometer Infrared Thermometer
10
The product is equipped with a class 2 laser. If the sign on the
device is not written in the language of your country, please affix the
sign above onto the device.
Do not point the laser beam at mirrors or other reflective surfaces.
The uncontrolled reflected beam may strike people or animals
Do not aim too close at hot or hazardous targets.
Keep this device and the batteries out of reach of children.
Small parts can be swallowed by children (under three years old).
Batteries contain harmful acids and may be hazardous if swallowed.
If a battery is swallowed, this can lead to serious internal burns and
death within two hours. If you suspect a battery could have been
swallowed or otherwise caught in the body, seek medical help
immediately.
Batteries must not be thrown into a fire, short-circuited, taken apart
or recharged. Risk of explosion!
Low batteries should be changed as soon as possible to prevent
damage caused by leaking.
Never use a combination of old and new batteries together, nor bat-
teries of different types.
Make sure the polarities are correct. Remove the batteries if the
device will not be used for an extended period of time.
Avoid contact with skin, eyes and mucous membranes when han-
dling leaking batteries. In case of contact, immediately rinse the
affected areas with water and consult a doctor.
Important information on product safety!
Do not expose the device to extreme temperatures, vibrations or
shocks.
Protect the device from high or abrupt temperature changes.
Do not leave the device near objects of high temperature.
Do not immerse the device in water. Water can penetrate and cause
malfunction. Protect it from moisture.
Check the housing before using the device. Do not use the device if
it seems to be damaged. Check for cracks or missing plastic parts.
Steam, dust, smoke, etc. can obstruct the unit optics and prevent
accurate measurement.
Thank you for choosing this instrument from TFA.
1. Before you use this product
Please make sure you read the instruction manual carefully.
Following and respecting the instructions in your manual will pre-
vent damage to your instrument and loss of your statutory rights
arising from defects due to incorrect use.
We shall not be liable for any damage occurring as a result of
non-following of these instructions. Likewise, we take no respon-
sibility for any incorrect readings or for any consequences result-
ing from them.
Please pay particular attention to the safety notices!
Please keep this instruction manual safe for future reference.
2. Range of application
We are confident you will find many uses for your non-contact ther-
mometer. It is compact and easy to use. Within one second you can
safely measure surface temperatures without contact, even of hot,
hazardous, or hard-to-reach objects.
With the laser pointer the measuring point can be focused exactly.
3. For your safety
This product is exclusively intended for the range of application
described above. It should only be used as described within these
instructions.
Unauthorized repairs, alterations or changes to the product are pro-
hibited and might result in dangerous laser radiation.
The product is not suitable for taking body temperature.
Caution!
Risk of injury:
Attention! Class 2 laser.
Never look directly into the laser beam.
Do not direct the laser beam into the eyes
of a person or animal.
It may cause permanent eye damage.
Wavelength: 635 - 650 nm | Output: <1mW
EN 60825-1:2015-07
TFA Anl. No. 31.1115_11_23 06.11.2023 11:47 Uhr Seite 6

Other manuals for TFA ScanTemp 410

Related product manuals