Warning: After removing the wall plate, if you find that it
is mounted on a junction box (e.g. a box similar to one
behind a light switch or electric outlet), high voltage cir-
cuit may be present and there is a danger of electric
shock. Please consult a qualified electrician.
2.3 Wire Labeling
1.Disconnect and identify each wire.
2.Tape the wires to the wall to keep them from slipping
through the hole in the wall. If the hole in the wall is
larger than necessary, fill it in order to prevent hot or
cold air to penetrate the thermostat. In this manner,
the thermostat will function perfectly.
2.4 Choosing a Location
For a new installation, choose a mounting location:
1. About 5 feet (1.5 meter) above the floor in an area with
good air circulation.
6
To Next Page
Loading...