The Fire Brick D95 - Page 16

16
What’s In the Kit
FIBREGLASS DOME FORMWORK
To lay the last few rows of bricks in the dome we provide you with a breglass dome form, made to the same
curve as the oven dome. It comes with a round timber support, to spread the load when you jack it into position.
HYBRID REFRACTORY BEDDING MORTAR
Dry Airset Refractory Mortar: 1 x 20kg bag
This is the mortar you will use to lay the re brick tiles that make up the oven oor. Please be aware that you
will need to mix the Airset mortar with General Purpose Cement, Hydrated Lime and Washed Sand* in the ratio
shown on the bag. This makes a smooth hybrid mortar mix perfectly suited to bedding down re bricks for
oven oors.
REFRACTORY MORTAR (TWO PART MIXTURE)
Refractory Mortar Part A: 3 x 25kg bags
Refractory Mortar Part B: 1 x 25kg bag
This is the mortar you’ll use to lay all of the remaining bricks in the kit. It is rated to ll joints up to 80mm width.
PRECAST FLUE GALLERY
The PreCast Flue Gallery is the molded section that ts over the brick arches at the front of the oven. Made
from refractory castable and reinforced with stainless steel bres, it’s tted with 7” Stainless Steel Flue sleeve,
ready to attach the ue section onto. A brushed stainless steel ring covers the ue expansion joint.
CERAMIC FIBRE BLANKET
One full roll and one half roll of 25mm thick Ceramic Fibre Blanket are provided, which will give you two full
layers over your brick dome for 50mm coverage which is precisely what we recommend.
PERLITE RENDER
LiteFill Perlite: 2 x 100L bags
This is the material you will use to cover the Ceramic Fibre Blanket layer, which you will be mixing with GP
Cement, Hydrated Lime and Washed Sand* to make a high-build Render mixture. There is enough Perlite in
the kit to build up a 50mm shell of render over the oven dome, with plenty left in reserve if some is wasted on
accident.
* Sand, Hydrated Lime and GP Cement are available at hardware stores and need to be purchased in addition to the kit.
STAINLESS STEEL FLUE & HAT
1 x 7” Stainless Steel Flue - 900mm Length 1 x 7” Stainless Steel Cowling
Kit Contents