The GigRig Wetter Box Quick Start Guide

Wetter Box QuickStart Guide
Insert your A pedal here
Leave this loop empty
and A becomes your
direct sound
To use stereo effects use
TRS cables here. Stereo
effects can be MONO
send STEREO return, or
STEREO send and
STEREO return
This is your standard MONO output
It can connect to either your amp, or
your amps FX LOOP RETURN
The right output is
only active when
using stereo effects
Select MONO for normal operation
For STEREO input use TRS cable
Adjust level on the
LOOP returns
Connect your guitar
signal or your amps
FX LOOP SEND here
Use standard cable
for MONO or TRS for
STEREO
Switch between MIX
mode (A+B) or
BLEND mode (A<>B)
Flips the relative
PHASE in LOOP B
Use any latching 1/4”
switch for REMOTE
switching
Control your mix/blend in real time
with an expression pedal such as
the purpose made WBX-1
Uses a standard 2.1mm centre negative connector (Current draw - 175mA)
Insert your B pedal here
This can be either a
standard mono pedal or
a stereo pedal
For stereo effects use a
TRS cable
OUT LEFT
LOOP B
LOOP A
OUT RIGHT
INPUT: MONO - STEREO
GAIN CONTROLS
INPUT
D.C. INPUT -
MIX/BLEND
PHASE LOOP B
EXP PEDAL INPUT
REMOTE SWITCH INPUT

The GigRig Wetter Box Specifications

Power

supply voltage	9V DC
max current	185mA

Input Specifications

input impedance (true bypass)	Source impedance
max input level (true bypass)	Source maximum
input impedance (buffered/trails bypass)	1MΩ
max input level (buffered/trails bypass)	+/- 8.5V

Output Specifications

output impedance (true bypass)	Source impedance
max output level (true bypass)	Source Level
gain (true bypass)	0dB(V)
bandwidth (bypass – trails mode)	10Hz – 85KHz
output impedance (bypass – trails mode)	27Ω
noise (bypass – trails mode)	3nV/√Hz
max output level (bypass – trails mode)	+/- 8.5V
gain (bypass – trails mode)	+6dB(V)