• While holding the screw in position with a screwdriver, tighten the locknut with a spanner.
• Check to make sure, flat washer (C) is loose enough to be turned by your finger.
Tightening the screw too tightly may make it impossible for the blades to move. Conversely, not tightening the
screw sufficiently may make the blades feel dull and cause leaves and branches to become caught in the
blades.
STORAGE
For years of trouble free service, make sure the machine is clean and dry before storing.
Before storing, clean the machine thoroughly as indicated above.
Store indoors or in a safe, locked protected area during severe weather and winter months.
DO NOT STORE in an enclosed area, where fuel vapors can reach an open hot flame.
DO NOT STORE fuel in the machine. Ensure fuel is removed from the fuel tank and carburetor.
If storing for an extended period, inspect, clean and repair the machine if necessary. Remove all fuel from the
fuel tank. Start the engine, this will remove all fuel from the carburetor and fuel lines. Remove the spark plug,
pour a small quantity of 2-stroke oil into the spark plug hole of the cylinder and re-seat spark plug. Store in a
clean, dry, dust free area.
DO NOT STORE fuel for longer than 30 days. Fuel can become stale and cause damage to the engine
carburettor, which is not covered by the machines manufacturer’s warranty.
To Next Page