7. DIY technical solutions
The display board is working but the motor doesn’t work
Charging doesn’t work
Can’t turn on the scooter
1. The break handle is
damaged.
2. The speed regulating
steering handle is
damaged.
3. The motor is damaged.
1. The battery charging port
is loose.
2. The connection of the
charger plug is not well.
1. The battery is dead.
2. The power button is out
of order.
1. Pull out the socket of the break handle (normally open type brake handle), if the motor
works, then it is the failure of break handle, should replace the break handle.
2. Firstly check the speed regulating steering handle and motor’s hall switch are short circuit
or not. Generally it is easier to cause the joint short circuit after rain affected with damp, so
notice the short circuit of steering handle and the motor hall switch. Otherwise there will be a
continuous damage of the replacement controller!
3. If the motor doesn’t work turn, please inspect the motor’s hall switch and turning ha ndle s
signal. Once the power on, the controller shall be very hot, generally it is short circuit of the
controller internal power tube, should immediately cut off the power.
1. Change a good charging port.
2. Change a good charger connector.
1. Charge the scooter for 1-2 hours according to the user manual..
2. Check the power button which has got stuck or not..
To Next Page
Loading...
