Main Wing
3
Wing Jioner
5x29x108mm
PB 2 x 25mm Screw
6
Ø
Please look for pin-hole marks at under side of control surfaces.
1mm pilot holes for The Wings Maker tri-horn are pre-drilled.
Apply instant type CA glue to both sides of each hinge.
Please dry fit wing joiner into left and right wing to make sure they fit with
the proper dihedral angle, mark the wing joiner if necessary. Apply epoxy
glue to both sides of all surfaces in contact. Use a stick to apply the glue
to inner side of wing joiner sleeve, and apply the glue to wing joiner before
putting them together. Wing joiner not glued properly will lead to wing failure
and plane crash.
TWM PL8210010
CLEVIS WRENCH
GA014PO28971303
To Next Page
Loading...