What to do if my Thermador PRD364WIGU displays an electronics fault?
If your Thermador Cookers has an electronics fault, disconnect the appliance from the power supply, wait a few seconds, and then reconnect it. If the error message persists, contact Customer Support.
Why is Thermador Ranges igniter constantly sparking?
If the igniter in your Thermador Ranges is constantly sparking, it could be due to improper grounding or an incorrectly polarized electrical power supply. It is recommended to have a qualified electrician ground the range properly, referring to the Installation Instructions.
Why more than four clicks of igniter before lighting in Thermador Ranges?
If you're experiencing more than four clicks of the igniter before lighting in your Thermador Ranges, the burner cap might not be properly fitted onto the burner base. Align the burner cap correctly on the burner base.
Why Thermador Ranges oven operates on bake but fails to operate on timed bake?
If your Thermador Ranges oven operates on bake but fails to operate on timed bake, the timer might be improperly set.
Why does the no pot indicator blink and turn off on my Thermador PRD364WIGU?
If the no pot indicator blinks and turns off on your Thermador Cookers, it means the cooking zone isn't detecting cookware. Ensure you place cookware on the cooking zone within 30 seconds of setting a power level. Also, verify that your cookware is suitable for induction cooking.
What should I do if the supply voltage is incorrect for my Thermador Cookers?
If the supply voltage to your Thermador Cookers is incorrect, and outside the normal operating range, contact your electrical utility provider.
What to do if the electronics in my Thermador Cookers have overheated and have switched off the induction module?
If the electronics have overheated and switched off the induction module, wait until the electronics have cooled down sufficiently. Then, touch any symbol on the display panel.
What to do if the No Pot display indicator blinks and turns off on my Thermador PRD364WIGU Cookers?
If the No Pot display indicator blinks and turns off, the pan detection is not detecting any cookware. Check whether the cookware is magnetic by using a magnet. Also, verify whether the cookware has a sufficiently large diameter.
Why is hot air coming from my Thermador Ranges?
It's normal for Thermador Ranges to push heated air into the room during the cooling process when the oven is on. Also, the fan speed will increase and decrease during different modes, which is also normal.
What to do if my Thermador PRD364WIGU shows the 'No Pot' display?
If the 'No Pot' display appears on your Thermador Cookers, check if your cookware is magnetic by using a magnet. Also, ensure that the cookware's diameter is sufficiently large for the cooking zone.
General| Brand | Thermador |
|---|---|
| Model | PRD364WIGU |
| Category | Cookers |
| Fuel Type | Gas |
| Number of Burners | 6 |
| Oven Type | Convection |
| Color | Stainless Steel |
| Width | 36 in |
To Next Page
