Thermador PRSE48 - User Manual

Page 1
C
A
N
A
D
IA
N
G
A
S
A
S
S
O
C
IA
TIO
N
APPROVED
®
DUAL-FUEL MODELS PRSE304, PRSE36 AND PRSE48
WARNING: Disconnect power before
installing. Before turning power ON,
be sure that all controls are in the
OFF position.
Gas Supply:
Natural Gas – 6 inch water column.
Propane Gas – 11 inch water column.
Electrical Power Supply:
PRSG304 and PRSG36 Models – 120 VAC, 60 Hz., 1Ph., 15 Amp circuit.
PRSE304 Model - 120/240 VAC, 60 Hz., 1Ph., 20 Amp circuit.
PRSE36 Models – 120/240 VAC, 60 Hz., 1Ph., 30 Amp circuit.
PRSE48 Models – 120/240 VAC, 60 Hz., 1Ph., 50 Amp circuit.
IMPORTANT: Save these instructions for the Local Electrical Inspector’s use.
INSTALLER: Please leave these Installation Instructions with this unit for the owner.
OWNER: Please retain these instructions for future reference.
PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING.
IMPORTANT: LOCAL CODES VARY. INSTALLATION, ELECTRICAL CONNECTIONS,
GAS CONNECTIONS, AND GROUNDING MUST COMPLY WITH ALL APPLICABLE CODES.
INSTALLATION INSTRUCTIONS MANUAL
PROFESSIONAL RANGES
For Residential Use Only
ALL-GAS MODELS PRSG304 AND PRSG36,

Summary

Important Installation Information

Introduction to Thermador Professional Ranges

Overview of Thermador Professional ranges and models.

Ventilation Requirements

Details on hood and ductwork installation for safety and performance.

Step 2: Cabinet Preparation

Gas & Electrical Supply Zones

Defines specific areas for gas and electrical connections.

Step 3: Unpacking, Moving and Placing the Range

Dolly Positioning and Floor Protection

Guidance on safe movement using a dolly and protecting the floor.

Step 4: Installing Anti-Tip Device

Parts Required and Mounting Instructions

Lists components and detailed steps for anti-tip device installation.

Wall and Floor Mounting

Specific instructions for securing the anti-tip bracket to walls or floors.

Step 5: Gas Requirements and Hookup

Natural Gas and Propane Gas Specifications

Covers pressure, connection types, and conversion for gas supply.

Step 6: Electrical Requirements, Connection & Grounding

Electrical Circuit and Power Supply Requirements

Details voltage, amperage, and wiring for different models.

Connection Methods (3-Wire, 4-Wire, Hard-wiring)

Explains various electrical connection types and procedures.

Grounding Methods

Describes recommended and alternate grounding techniques.

Step 7: Backguard Installation

Backguard Attachment and Model Numbers

Instructions for attaching backguards and a kit number reference.

Step 8: Test and Adjustment

Burner and Flame Testing

Procedures for testing burner operation and flame characteristics.

Exterior Surface Care

Guidelines for cleaning and protecting the appliance's exterior.

Final Checklist

Installer Checklist

A comprehensive verification list for installers.

Thermador PRSE48 Specifications