Thermal Solutions EVS SERIES - Lighting Instructions

47
V. Lighting Instructions
• If you cannot reach your gas supplier, call the re
department.
C. Do not use this appliance if any part has been under
water. Immediately call a qualied service technician
to inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
A. This appliance is equipped with an ignition device
which automatically lights the pilot. Do NOT try to
light the pilot by hand.
B. BEFORE OPERATING smell all around the appliance
area for gas. Be sure to smell next to the oor because
some gas is heavier than air and will settle on the oor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any
phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier’s
instructions.
FOR YOUR SAFETY, READ BEFORE OPERATING
WARNING: If you do not follow these instructions exactly, a re or explosion may result
causing property damage, personal injury, or loss of life.
1. STOP! Read all the safety information (warnings,
cautions etc.) in this manual.
2. Turn off all electric power to the appliance.
3. Set the system control so that there is no call for
heat to the appliance.
4. This appliance is equipped with an ignition device
which automatically lights the pilot and main burner.
Do not try to light the pilot or main ame by hand.
5. Remove front door panel.
6. Locate the gas pilot valve at the rear of the
appliance.
7. Locate the gas main valves at the rear of the
appliance and at the end of the gas supply pipe
inside the appliance.
8. Rotate gas shutoff valves clockwise from
"ON" position to "OFF". Make sure handle rests
against stop.
9. Wait ve (5) minutes to clear out any gas. Then
smell for gas, including near the oor. If you smell
gas, STOP! Follow "B" in the safety information
above on this label. If you do not smell gas, go to
the next step.
10. Rotate gas shutoff valves counterclockwise
from "OFF" to "ON". Make sure handle rests
against stop. Do not force.
12. Turn on all electric power to the appliance.
13. Set thermostat to desired setting.
14. If the appliance will not operate, follow
the instructions " TO TURN OFF GAS TO
APPLIANCE" and call your service technician or
gas supplier.
15. Move the switch to the "ON" position.
16. Set system control so that there is a call for heat
from the system.
17. Observe prepurge, pilot ignition and main ame
ignition.
18. If pilot or main ame ignition does not occur
during initial attempt, remove the upper front jacket
panel of the appliance. If the appliance pilot and
main ame light, go to step 20.
OPERATING INSTRUCTIONS