Need help?Do you have a question about the THERMEAU S125 and is the answer not in the manual?
Record model, serial number, purchase date, and dealer details for future reference.
Provides phone numbers for service assistance in Canada and the USA.
Explains the meaning of IMPORTANT, CAUTION, and WARNING signs used in the manual.
Emphasizes qualified electrician for wiring and proper outdoor installation clearances.
Highlights the importance of pool chemistry for heater longevity and provides standards.
Details voltage, amperage, motor HP, flow rates, and dimensions for residential models.
Lists compressor size, heat exchanger type, heating range, voltage, breaker, and weight for commercial models.
Discusses optimal placement for efficiency and access, ventilation, and clearance needs.
Details the correct sequence of pool pump, filter, and heater, and recommended piping materials.
Explains that multiple units must be plumbed in parallel for equal water flow and optimum operation.
Stresses that wiring must be done by a qualified electrician according to local requirements.
Explains the necessity of bonding all metal components of the pool system for safety.
Provides step-by-step instructions for check valve, chlorine system, and filter placement.
Guides on how to access the control box and connect electrical supply.
Explains the unit's protection against phase issues and how to identify/resolve them.
Shows wiring diagrams for single-phase units with single or dual compressors.
Provides the wiring diagram for three-phase units.
Describes the control panel's display and buttons for temperature and parameter settings.
Details the buttons (SET, UP, DOWN) and available modes (POOL, SPA, P-S, C-F) for temperature adjustment.
Explains how to set temperature points for pool and spa modes and the memory retention feature.
Outlines steps to connect 2-wire remote systems to the control board's P/S terminal.
Guides on connecting 3-wire remote systems to the control board's P/S terminals.
Emphasizes verifying the breaker is ON and water circulation is active before starting.
Explains the sequence of fan and compressor startup, normal operation indicators, and condensation.
Lists and explains various display codes (OFF, LP, HP, Po, Pc, FLo, dPo, dPc, FS) and their meanings.
Provides solutions for when the pool heater is not running, including control settings and breaker issues.
Offers steps to resolve the 'flo' error, related to pool pump and filter status.
Explains reasons for the fan running without the compressor, such as protection mode or defrost cycle.
Advises checking power supply connections with an electrician for units with no display.
Differentiates normal condensation from potential leaks and advises on checking.
Lists causes for not reaching desired temperature, like heat loss, dirty evaporator, or restricted water flow.
Details how to get service, what information to provide, and the importance of proof of purchase for warranty.
Explains how to clean the evaporator and cabinet for regular maintenance.
Provides steps for draining, disconnecting, and protecting the unit for winter storage.
Outlines the warranty period for parts, labor, and the compressor for commercial units.
Details conditions that void the warranty and exclusions from coverage.
Specifies the warranty periods for parts, labor, and the titanium heat exchanger for residential units.
Lists situations that void the warranty and necessary installation/maintenance compliance.
Details warranty coverage, including part and labor periods and titanium heat exchanger warranty for Florida.
Lists conditions that void the warranty and exclusions specific to Florida State warranty terms.
General| Brand | THERMEAU |
|---|---|
| Model | S125 |
| Category | Swimming Pool Pump |
| Language | English |
To Next Page
