THERMEx VERTICAL 260 - Maintenance and Cleaning Procedures; Recirculation System

THERMEX VERTICAL 260 B 540231261206082018
58
The light is turned o by pressing the button on/o lights
RECIRCULATION
The hood can be used for recirculation. This is used in kitchens and locations where there is no
possibility of venting into open-air. The air is sucked first through the grease filter and then
through a filter with activated carbon which removes odours.
NOTE: One recirculation filter must be used, and it is not included in the purchase of the hood,
although it can be bought as accessories. The product number on a recirculation filter is
535.23.0575.9.
The recirculation filter is installed on the motor inside the hood, and are installed as follows:
• Open the glas door.
• Remove the grease filter.
• Re-attach the filter
• Close the glas door
MAINTENANCE AND CLEANING
• Always disconnect power before cleaning.
• The hood must be cleaned regularly to ensure optimal operation and long service life.
• Grease and dust debris are collected in the filter and may risk igniting with insucient
cleaning.
ENGLISH
»
MAINTENANCE AND CLEANING
Mount the recirculation filter on the grease filter.