( iii )
SAFETY INFORMATION
WARNING SYMBOLS
The following is an explanation of the warning symbols seen on the instrument. Please read
this information before using and/or maintaining this equipment.
As seen on End Plate 1 near the battery compartment lid.
CAUTION:
Only use battery types defined in this manual
complying with IEC 86-1&2. Insert batteries
with correct polarity (see the drawing on the back
label).
As seen on End Moulding 2 near the DC input label.
CAUTION:
CAUTION:
Only use approved power supply adaptors from
the list in section 3.8. The power supply should
not be capable of delivering more than 250 mA
DC current.
Do not recharge non-rechargeable, primary,
alkaline manganese cells. When using these cells,
ensure the end cap covers the DC INPUT jack
under the end moulding (as set in the factory).
As seen on End Moulding 2 near the Probe label.
CAUTION:
Risk of non hazardous electric shock.
Turn the instrument off before connecting and
disconnecting probe. High voltage up to 1400 V
(maximum power 45 mW) at the probe connector.
To Next Page
Loading...
