EPD/HB/40521/
000
ELECTRONIC PERSONAL DOSEMETER HANDBOOK
MAINTENANCE
ISSUE 5
Page 86
Thermo
6.3 EPD Clip Assembly
Depending on customer requirements, the EPD may (or may not) be fitted with a
clip assembly. The clip assembly comprises a lanyard plate and a spring clip,
which allows the user to attach the EPD to an outer garment (see Section 2.1.6).
The clip assembly is attached to the EPD by the lanyard plate. The lanyard plate
slots into a recess in the EPD case (see Figure 6.1). Retaining lugs secure the
lanyard plate in position.
Figure 6.1 - EPD Case Clip Assembly Recess
The lanyard plate may not be fitted with the spring clip (again depending on
customer requirements) (see Figure 6.3). This makes the unit more comfortable
to wear with the lanyard, when the clip is not required. If the EPD is shipped with
the spring clip fitted to the lanyard plate it should be considered as an integral
item. Removal of the clip from the lanyard plate is not recommended.
To Next Page
Loading...
