Thermo King ClimaAIRE I D TK 60065 User Manual

Alarms
The Red Alarm Symbol will illuminate in the following two
conditions:
• high or low pressure switches are off longer than 10 minutes
• high or low pressure switches are off 5 times per 10 minutes
(flash on and off).
In both cases, the unit will switch to the Ventilation mode.
The Yellow Alarm Symbol will illuminate in case of temperature
sensors failure.
Yellow Alarm number will be shown on the display for 5 seconds.
Red Alarm number will stay on the display till any button is pushed.
To restart the unit, press twice the key ON/OFF (1) to switch OFF
and ON the unit.
Warranty Instructions
Should you require warranty service during the warranty period,
simply present your copy of the Warranty Certificate at any of the
dealer locations shown in the Thermo King Service Directory. Terms
of the complete Thermo King Corporation Warranty are available on
request.
Controller
Operator’s
Manual
Control Panel Descriptions
Operating Instructions
Alarms
ATTENTION: If the alarm comes up again, don’t
restart and see your nearest dealer for service.
CAUTION: The unit can automatically start and run
anytime the ignition key is in the ON or OFF position.
No matter if the ON/OFF switch is ON or OFF
(depends on setup program).
RED YELLOW
BEA133
BEA178
TK 60065-3-PC (03-07)
Copyright©2007 Ingersoll Rand CCT - ESA
CAUTION: This is a driver’s reference guide.
If further information is required, consult your
Thermo King service directory for the location
and phone of the local dealer.

Thermo King ClimaAIRE I D TK 60065 Specifications

General

Type	Controller
Model	ClimaAIRE I D TK 60065
Manufacturer	Thermo King
Protection Rating	IP65
Communication Interface	CAN bus

Summary

Alarms and Fault Indicators

Red Alarm Symbol Conditions

Explains conditions for the Red Alarm Symbol illumination and unit behavior.

Yellow Alarm Symbol Conditions

Explains conditions for the Yellow Alarm Symbol illumination and display behavior.

Restarting the Unit After Alarm

Instructions on how to restart the unit after an alarm occurs.

Automatic Operation Safety Caution

Warning about the unit automatically starting and running at any time.

Warranty and Service Information

Warranty Service Procedure

Guidance on obtaining warranty service during the warranty period.

Reference Guide Note

Notes that this is a driver's reference guide, advises consulting service directory.

Control Panel Description and Operation

ON/OFF Key Function

Instructions for turning the system ON and OFF using the designated key.

Mode Selection Key

Details on selecting operating modes: Auto, A/C, Heat, and Ventilation.

Temperature Adjustment Keys

How to decrease or increase temperature setpoint and scroll through menus.

Blower Speed Selection

Explanation of blower speed settings: Auto, High, Medium, and Low.

Fresh or Recirculated Air Selection

How to select air intake mode: Automatic, Fresh air, or Recirculated air.

Display Information

Explanation of symbols and information displayed on the unit's screen.