Need help?Do you have a question about the Thermo Scientific FD1530M and is the answer not in the manual?
General| Model | FD1530M |
|---|---|
| Temperature Uniformity | ±5°C |
| Chamber Volume | 15 Liters |
| Power Supply | 200-240V, 50/60 Hz, Single Phase |
| Control System | Digital PID Controller |
| Atmosphere | Air |
| Weight | Approximately 120 kg |
| Insulation | Ceramic fiber |
| Heating Element | Molybdenum disilicide (MoSi2) |
| Max Heating Rate | 10°C per minute |
Identifies warning, caution, and note symbols used in the manual.
Lists essential safety precautions for electrical shock, burns, and personal injury.
Warns about potential exposure to ceramic fibers and crystalline silica.
Specifies the proper applications and temperature ranges for the furnace.
Advises against using the product for anything other than its intended purpose.
Explains how the furnace chamber is heated and its safety features.
Details operating and storage temperature, humidity, and altitude limits.
Lists standards the product conforms to and authorized EU representative.
Instructions for choosing a suitable location and providing ventilation.
Guidance on electrical specifications and connection procedures.
Details about power switch, cycle light, door switches, and digital display.
Overview of the single setpoint controller with OTP features.
How the controller performs on power-up and displays values.
Explains the function of each button and indicator light on the controller.
Lists and defines various control parameters for the setpoint controller.
Lists and defines Proportional, Integral, and Derivative parameters.
Describes alarm conditions and messages displayed by the controller.
Explains the function for detecting thermocouple open circuits.
Details the OTP function and how to change its value.
Explains the process of tuning the controller for optimal accuracy.
Describes the ramp and dwell programming capabilities and modes.
Explains the different operating modes available for ramp and dwell programming.
Explains how to set program mode, ramp rate, and dwell time.
Covers basic operation, buttons, indicators, and display windows.
Details parameters, PID lists, access codes, and alarms.
Guides on programming, holdback, cycles, and running programs.
Explains tuning methods, error handling, and gain scheduling.
Best practices for loading the furnace chamber for uniform heating.
Discusses causes of element failure and housekeeping tips.
Information on extending element life and thermocouple accuracy.
Instructions for cleaning the exterior of the furnace unit.
Step-by-step instructions for replacing a heating element.
Step-by-step instructions for replacing the thermocouple.
Step-by-step instructions for replacing the door switch.
Instructions for adjusting the door switches for proper function.
Instructions for removing and replacing the controller unit.
To Next Page
