Need help?Do you have a question about the Thermo Scientific 47900 and is the answer not in the manual?
General| Brand | Thermo Scientific |
|---|---|
| Model | 47900 |
| Category | Furnace |
| Language | English |
Describes warning symbols and their meaning.
General statement about furnace design and manual importance.
Covers electrical, burn, and personal injury warnings.
Describes the furnace's purpose as a general-purpose laboratory furnace.
States the product should only be used for its intended purpose.
Explains how the furnace heats and is controlled.
Details dimensions, volume, weight, and electrical ratings.
Details dimensions, volume, weight, and electrical ratings.
Specifies operating and storage conditions, altitude limits.
Guidelines for choosing a suitable location for the furnace.
Instructions for connecting the furnace to the power supply.
Specific electrical requirements for EU models.
Describes the ON/OFF switch and digital display illumination.
Explains the function of the cycle light on the display.
Details the door safety switch and its operation.
Introduction to the controller and basic operation.
Describes buttons, indicators, and parameters.
Covers alarms, sensor/over-temp protection, and tuning.
Details functions, program overview, rate setup, and execution.
Covers controller overview, interface, buttons, and basic setup.
Includes setpoint selection, ramp rates, units, tuning, parameters, and offsets.
Details alarms, sensor break, loop break, and over-temperature protection.
Covers segment types, various timer modes, programmer configuration, and auto/manual modes.
Information on adapters and RS 485 connections.
Covers software, parameters, and communication issues.
Describes exterior cleaning and general upkeep.
Procedures for element and thermocouple replacement.
Instructions for door switch maintenance.
Procedure for controller replacement.
Lists parts for single setpoint models.
Lists parts for models with OTP.
Lists parts for 8 segment models.
Lists parts for 5x16 segment models.
Electrical schematic for single setpoint models.
Electrical schematic for single setpoint models with OTP.
Electrical schematic for 8 setpoint programmable models with OTP.
Electrical schematic for 8 segment programmable models.
Electrical schematic for 5x16 segment programmable models.
Details US and Canadian product safety standards compliance.
FCC statement on EMC compliance.
ISM digital apparatus compliance notice for Canada.
Covers Proposition 65, EU Directives, REACH, and RoHS compliance.
European Union Waste Electrical & Electronic Equipment directive compliance.
To Next Page
