Why does my Thermo Scientific Fisher Scientific SP88857290 say 'Over Temp'?
If your Thermo Scientific Cooktop shows 'Over Temp', it might be due to an OTP circuit failure or the OTP potentiometer being set too low. Try increasing the OTP setting to resolve the issue.
General| Brand | Thermo Scientific |
|---|---|
| Model | Fisher Scientific SP88857290 |
| Category | Cooktop |
| Language | English |
Explains the meaning of warning, caution, and note symbols used in the manual.
Covers essential safety guidelines for operating the Isotemp Advanced hot plates, stirrers, and stirring hotplates.
Identifies and describes the function of each key and indicator on the unit's control panel.
Details the procedure for adjusting the stirring speed using the control panel and knob.
Describes how to set the desired temperature using the control panel and knob for heating operations.
Explains how to connect and use an external probe for more precise solution temperature control.
Describes the built-in safety feature that prevents overheating by shutting off the unit if a set temperature limit is exceeded.
Lists common error messages, their intended detection, possible causes, and recommended solutions.
To Next Page
