Need help?Do you have a question about the Thermo Scientific PLR 221 and is the answer not in the manual?
General| Temperature Range | +2°C to +8°C |
|---|---|
| Defrost | Automatic |
| Refrigerant | R600a |
| Capacity | 221 liters |
| Power Supply | 220-240V/50Hz |
Do not modify system components; use O.E.M. parts only. Improper use can cause injury or death.
Improper operation may result in dangerous conditions. Follow instructions and design limits.
Install in a level, vibration-free area with 10cm side/top clearance and 15cm back clearance.
Ensure adequate space for airflow, door swing (min 85 degrees), and wall clearance.
Connect to correct power source; ensure proper grounding; do not use overloaded lines.
Units use 10/16 amp cords, rated for 220/230V AC, 50Hz. Use grounded outlets.
Adjust leveling screws to ensure the unit is level. Shim corners if the floor is uneven.
Instructions for manual defrosting of refrigerator and freezer units when frost exceeds 6mm.
Unit temps are factory set. Plug in, turn key to "I" position, allow 24 hours for desired temp.
Shows the user interface for PLR 221, PLR 386, PLR 1006 refrigerators.
Key must be in "I" for operation. Compressor indicator shows status.
Steps for turning unit on/off and setting interior temperature.
Procedure to set the high temperature alarm limit using the Set and arrow buttons.
Procedure to set the low temperature alarm limit using the Set and arrow buttons.
To Next Page