Thermo Scientific REVCO Series User Manual

Installation and Operation Manual
Thermo Scientific Revco
®
General Purpose, Flammable Storage,
and Explosion Proof
Laboratory Refrigerators and Freezers

Thermo Scientific REVCO Series Specifications

General

Defrost	Manual
Control	Microprocessor
Alarm System	Audible and visual alarms for temperature deviations
Material	Stainless steel or coated steel exterior
Application	Laboratory, pharmaceutical
Voltage	115V or 230V (depending on model)
Shelves	Adjustable shelves
Door Lock	Yes
Certifications	UL
Refrigerant	CFC-free

Summary

Introduction

Safety Considerations

Unpacking and Inspection

Installation

Location

Install the unit in a level area free from vibration and ambient heat.

Wiring

Connect the equipment to the correct power source and ensure proper grounding.

Leveling

Rotate leveling screws to ensure the unit is level and shim if necessary.

Door Seal

Check the door seal integrity by pulling a paper strip from between the door and gasket.

Operation

Temperature Control

Adjust cold controls to set the desired temperature, waiting 24 hours between adjustments.

Combination Refrigerator/Freezers

Understand temperature sensor location for combined units.

Defrosting

Turn off unit to melt frost exceeding 1/4 inch; do not use sharp objects.

Cleaning

Troubleshooting

Flammable Storage Units

Safety and Usage Standards

Follow guidelines for Class I, Division 2 storage of flammable liquids.

Electrical Requirements

Ensure proper grounding and use appropriate wiring for flammable storage units.

Explosion-Proof Units

Safety and Usage Standards

Approved for Class I, Division 1 locations; review flammable storage guidelines.

Electrical Requirements

Install using rigid metal conduit and a disconnect switch suitable for hazardous locations.