16
Electric Tankless Instant Water Heater -
Installation Manual and User Guide
EN
Mounting Instructions
Elex 6/8/8.5/9.6/10/12/15/18/21/24/3IN1 (P)
See image B1, B2
Remove the screw with a Phillips-head screwdriver and open the top cover� Remove the
display plug and remove the top cover and put beside� Detach the support from the bot-
tom housing�
See image B3, B4
1� Use two pieces of tape to fix the template on the wall where the device is to be in-
stalled�
2� Drill four 8mm holes through the template, as indicated in B3�
3� Install cold water inlet connector and gasket to cold water supply (in the wall) on the
right, and hot water outlet connector to hot water supply (in the wall) on the left, as
shown in B4� Teflon tape can be used for sealing the threads�
Make sure the arrow on the inlet connector outward from the wall.
See image B5, B6, B7, B8, B9, B10
4� Prepare the power cable with desired voltage and cut to the required length, as indi-
cated in B5.a and B5.b�
5� Insert the anchors into the drilled holes and install the appliance with the supplied
screws and spacers, as indicated in B6, B7 and B8�
6� Install the hot water pipe to the left, and install the cold-water supply to the right, as
indicated in B9� Make sure the connections are watertight! To prepare the connection
to the water supply, Teflon tape can be used for sealing the threads�
7� Connect the power cable to the terminal block, press the button to reset the switch,
as indicated in B10�
Power supply must be confirmed before wiring!
This appliance must be earthed properly!
Earth leakage circuit breaker must be installed!
The electrical connection should be made by a qualified electrician, in accordance
with the relevant regulations (IEC, NEC, etc.)
See image B11, B12
8� Install the back panel, adjust the power setting (only for 3IN1(P) models), insert the
display plug, install the top of the housing, and install the screw at the bottom, as
indicated in B11�
9� Install the hot water pipe to the left, and install the cold water supply to the right�
Make sure the connections are watertight, as indicated in B12�
10� Switch on the circuit breaker, turn on the appliance and open the hot water tap,
wait for about 20 secs before the appliance start working�
Make sure only fittings for close-outlet water heaters can be used!
Make sure the filter mat in the inlet is installed!
To Next Page
Loading...
Need help?
General
