25
DE NL GB F TR PLDE NL GB F TR PL
Connection to the electricity supply
The device must be filled with water (see above). Only then may the
appliance be connected to the electricity supply (insert the plug in the
wall socket). Connection of the device to the power supply network
must take place in accordance with electric installation standards and
as specified by local laws and regulations. The device must be directly
connected to the power supply network (230V) via an electrical ca-
ble and plug.
Avoid danger from damaged power supply cables. In the event of
damage, the device must be replaced by the manufacturer or its cus-
tomer service department, or by an equivalently-qualified person.
Ensure that the addition of this boiler will not overload the fuse pro-
tection in your mains.
Internal modifications to the product may cause problems if this work
is not carried out by authorized and qualified technical staff. The war-
ranty only applies if the product has not been modified in any way, i.e.
subject to it being in unchanged condition.
In order to avoid creating an unsafe situation by inappropriate reset-
ting of the maximum temperature safety device, this unit may not be
powered via an external switching device (a time switch for example)
or connected to a circuit, which is regularly switched on and off by
the power supply company.
Technical specications
Description Over-sink | Under-sink
Wall mounting Vertical
Nominal volume Litres 5,3
Construction Open
Heat loss Wh/h 12,5
Maximum recommended water volume
Litres/
minute
5
Nominal capacity kW 2
Nominal voltage V 1/N/PE 230V
Frequency Hz 50
Protection class I I
IP rating
IP24
Water connection Inches
G½“ | G⅜“
Connector material Brass
Dimensions (h x w x d) mm 420x270x180
Temperature range °C 35 - 75
Distance, pipe to wall mm 85
Weight when empty kg 2,8
Operating pressure MPa 0
Daily electricity consumption Q
elec
0,197 kWh
Load profile 3XS
Sound power level L
WA
16 dB
Energy efficiency
η
wh3
42,0 %
3. User instructions
The device must be filled with water before connection to the
electrical supply!
When powering up for the first time, you must verify that the tem-
perature indicator (light) extinguishes when the required tempera-
ture is reached (the device has reached the set temperature). The
device only switches on again if the temperature falls below this set-
ting. (See troubleshooting)
When filling for the first time, the hot water valve in the low-pressure tap fitting must be
open so that water can flow into the device. If the device is not filled with water before-
hand during installation, the automatic safety device will activate and switch off the appli-
ance. (See troubleshooting instructions on how to act in the event of a fault.)
To Next Page
Loading...
Need help?
General
