EasyManuals Logo

ThermoProbe TP9-A User Manual

ThermoProbe TP9-A
10 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
05/
2021, JK
USER INSTRUCTIONS - TP7-D & TP9-A
INTRODUCTION
T
his manual describes the basic function, use and safety instructions for a model TP7-D and TP9-A portable digital
thermometer instrument.
REPLACING BATTERY
W
hen the battery voltage is low, the low battery icon will show on the display.
When the battery voltage is very low, the backlight will no longer operate and the low battery icon will ‘blink’ on the
display.
Replace batteries as soon as possible in a safe location after the low battery is noticed. This will ensure backlight
operation, and avoid possible malfunctioning. Do not attempt to calibrate the instrument if the low battery indicator is
displayed.
WARNING:
Ba
tteries must be changed in Non-hazardous area.
Batteries must be of correct approved type.
Batteries must be installed with correct polarity making sure the (+) end of the battery is aligned with (+)
symbol embossed in the battery case.
Batteries must not be installed with polarity reversed where one cell could charge another cell.
New batteries must not be mixed with old batteries. Batteries must not be mixed with batteries of other
models or manufacturers.
a) Ensure the instrument is in a non-hazardous area & powered off.
b) Use a #2 Phillips drive to remove the 3 screws holding the front cover on the TP7-D or the 2 screws holding the
front cover on the TP9-A.
c) Use a #1 Phillips drive to remove the single screw from the battery cover. Remove the battery cover, push one
battery towards the spring contact and lift battery up from the holder, and then remove the remaining battery.
d) Install each new battery making sure the (+) end of the battery is aligned with (+) symbol embossed in the battery
case.
e) Replace the retaining device and reinstall the cover.
CERTIFIED Batteries for the TP9-A and TP7-D are as follows:
Manufacturer Type Part Number
Duracell AA (LR6) Alkaline MN1500
Panasonic AA (LR6) Alkaline LR6XWA
GP (Gold Peak) AA (LR6) Alkaline GP15A
AUTHORIZED REPAIR
I
t is recommended that service beyond the scope of this manual be performed by ThermoProbe, Inc. or one of its
authorized distributors.
w ww. . com
information@itm.com1.800.561.8187

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ThermoProbe TP9-A and is the answer not in the manual?

ThermoProbe TP9-A Specifications

General IconGeneral
BrandThermoProbe
ModelTP9-A
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals