What to do if my Thermor Aeromax Piscine 10 Heat Pump pool water is not warm enough?
If the pool water is not warm enough, try these steps: switch to heating mode, raise the temperature setpoint, increase the time, and cover the pool when it is not in use.
What to do if my Thermor Heat Pump has excessive water inlet/ outlet temperature difference?
If there's an excessive water inlet/outlet temperature difference in your Thermor Heat Pump, you can try the following: remove the cause of any blockage, increase the water flow volume, or restart, repair, or replace the water pump.
What to do if my Thermor Aeromax Piscine 10 Heat Pump has high-pressure protection?
If your Thermor Heat Pump is showing a high-pressure protection error, you can try to replace the high-pressure sensor, remove the cause of the blockage, or increase the water flow rate. If the issue persists, have the appliance repaired by a refrigeration engineer.
What to do if my Thermor Heat Pump pool water is too warm?
If the pool water is too warm, lower the temperature setpoint. Alternatively, switch to AUTO mode or COOLING mode with an appropriate setpoint.
What to do if my Thermor Heat Pump has a water flow rate sensor (Flow Switch) issue?
If you're experiencing issues with the water flow rate sensor (Flow Switch) on your Thermor Heat Pump, check the water circulation direction, reconnect the cable, change the sensor, or restart, repair or replace the water pump.
What to do if my Thermor Aeromax Piscine 10 Heat Pump has excessive water inlet/ outlet temperature failure?
If your Thermor Heat Pump shows an excessive water inlet/outlet temperature failure, try to increase the water flow rate or replace the sensors.
What to do if my Thermor Aeromax Piscine 10 Heat Pump has low-pressure protection?
If your Thermor Heat Pump is showing a low-pressure protection error, you can try to replace the low-pressure sensor, call in a refrigeration engineer to perform a sealing check on the circuit and a gas refill, or reduce the water flow rate.
What to do if my Thermor Aeromax Piscine 10 Heat Pump has a water leak on a connector?
If you notice a water leak on a connector of your Thermor Heat Pump, try to hand tighten it. If the leak persists, have the connector replaced.
What to do if my Thermor Heat Pump's Aéromax Piscine emits vibration noises?
If your Thermor Heat Pump's Aéromax Piscine is emitting vibration noises, try to replace the isolators or retighten the mountings. If the problem continues, contact your installation company.
What to do if my Thermor Aeromax Piscine 10 Heat Pump water inlet temperature sensor fails?
If you are experiencing issues with the water inlet temperature sensor on your Thermor Heat Pump, try to reconnect the sensor or replace it.
Essential safety advice for handling, installing, and using the appliance.
Safety guidelines for connecting hydraulic equipment and operating temperatures.
Requirements and safety measures for electrical connections.
Detailed performance and physical data for all Aeromax models.
Guidance on choosing the optimal and safe placement for the unit.
Procedures for connecting the water pipes to the heat pump.
Guidelines for safe and compliant electrical wiring of the unit.
Steps for safely shutting down the unit to prevent frost damage during winter.
Table of error codes, their causes, and solutions for troubleshooting issues.
To Next Page
General
