ThermoTex Thermo-Ident 2

Need help?

Do you have a question about the ThermoTex Thermo-Ident 2 and is the answer not in the manual?

Summary

Product Description and Specifications

General Description and Intended Use

Explains the machine's purpose for textile marking, including printing, cutting, and application of labels.

Technical Data

Safety Advice and Precautions

Dangerous Spots on Machine

Highlights hazardous areas like hot surfaces and moving parts that pose injury risks.

Operators Due Diligence

Outlines operator responsibilities for safe and proper machine operation.

Basic Safety in Standard Operation

Lists essential safety practices for daily use of the machine.

Safety for Maintenance and Servicing

Provides crucial safety guidelines for performing maintenance and repair tasks.

General Advice for Operation

Installation Advice

Recommendations for machine placement, power access, and environmental considerations.

Machine Start-up Procedure

Step-by-step instructions for connecting cables, power, and initial machine setup.

Thermal Print Head Properties

Important information on handling and maintaining the sensitive thermal print head.

Materials and Parameters

Details suitable marking tapes, ink ribbons, and recommended temperature/time settings.

General Operation Procedures

Principal Work Sequence

Describes the step-by-step process of printing and applying labels to textiles.

Inserting the Ink Ribbon Roll

Inserting the Marking Tape

Switching Marking Modes

Explains how to switch between temporary and permanent marking modes.

Control Unit Operation

Operating Display Overview

Menu Navigation

Outlines the different menu levels and how to navigate through settings.

Quick Access Buttons

Explains the function of F1, F2, and F3 buttons for rapid setting adjustments.

Operating Modes

Details the three available operating modes: Keyboard, RS232, and Ethernet.

Entering Text for Labels

Description of Menu Points

Numbering Configuration

Automatic Printing Setup

Label Type Selection

Label Length Configuration

Heat-Seal Temperature (Temporary)

Sets the heating plate temperature for temporary marking.

Heat-Seal Temperature (Permanent)

Sets the heating plate temperature for permanent marking.

Heat-Seal Time (Permanent)

Operating Mode Selection

Heating Energy Adjustment

Copy Logos from PC

Heat-Seal Removal Function

Remote Control and Communication

Serial Interface Configuration

Ethernet Connection Setup

PC to Thermo-Ident Data Transfer

Lists commands sent from a PC to control machine functions like printing and settings.

Thermo-Ident to PC Data Transfer

Lists status messages and acknowledgements sent from the machine back to the PC.

Error Messages Reference

Common Error Messages

Details common error messages displayed by the machine and their corresponding solutions.

Assistance with Faults and Troubleshooting

Troubleshooting Measures Guide

Provides a table of common faults, their causes, and recommended troubleshooting steps.

Servicing and Maintenance

Safety for Maintenance

Crucial safety precautions to be observed before and during maintenance tasks.

Cleaning the Print Head

Step-by-step instructions for cleaning the print head to maintain print quality.