To Next PageTo Next Page
Need help?Do you have a question about the Thetford 51802 and is the answer not in the manual?
General| Type | Portable Toilet |
|---|---|
| Color | White |
| Holding Tank Capacity | 5 gallons |
| Fresh Water Tank Capacity | 4 gallons |
| Weight | 5.5 kg (12 lbs) |
Remove waste-holding tank and pull handle from control panel.
Gently detach the control panel from the main unit.
Swing the waterfill funnel outwards for access.
Locate shaft pivot, remove spring from shaft.
Unscrew and remove the pivoting bracket.
Detach the link from the shaft and remove the shaft.
Detach the control knob from the unit.
Release and remove the cable connection using pliers.
Attach the cable plug to the new control knob.
Reinstall the new control knob onto the unit.
Remove tank, pull sight glass away from pipe.
Unscrew tunnel, press to release drain tube.
Insert new tube, reattach sight glass to pipe.
Secure the tunnel back into its original position.
Remove the waste holding tank from the cassette.
Detach the PCB cover from the inside of the unit.
Install new PCB, then reattach and secure the cover.
Use cover as lever to rotate mechanism counter-clockwise.
Detach the complete disc and mechanism assembly.
Take the float arm out of its retainer.
Install new arm, reverse process to replace mechanism.
Detach the waste-holding tank from the cassette toilet.
Slide seat/cover, remove two side screws.
Unscrew flange lock from the toilet bowl.
Take off the flange lock to remove the toilet bowl.
While removing bowl, detach nozzle by pulling downwards.
Unplug electrical connectors at the back of the toilet.
Turn bayonet to the right to detach and remove the pump.
Remove tube, push grommet, detach bayonet from wire.
Follow reverse steps to install the new pump.
