7
Tag Feeder Manual
HMI Displays
Ready Indicator: The indicator turns black when the tagger is ready to ac-
cept trigger signals.
The fault indicator turns black on any error that stops the tagger from ac-
cepting trigger signals.
Press the F1 key to stage/start the tagger.
Press the F2 key to put the tagger in a paused state.
Press the F3 key to reset a faulted condition.
Test cycle Manual. For further setup testing, press and release the F1 key to
cycle the machine. One tag should be dispensed and the next one staged to
the tag detect sensor. Repeat as necessary.
Test cycle Automatic. To automatically test the machine, it will need to be
put into ready mode rst. Press F3 and then F1. The indicator next to the
word READY should change to black.
Run a bag through the conveyor and into the sewing machine. The bag
should trip the sensor and turn on the feeder to dispense a tag into the sew-
ing machine which will bring the tag onto the bag.
To set the position of the tag on the bag, use the up / down arrows to either
increase or decrease the trigger delay.
Repeat until tag is in desired position. Please note that relocation of the
trigger sensor and reector may be needed if you run out of adjustment
either way.
To Next Page
Loading...