19
HOW TO FIT THE DRIVE SHAFT AND BOWL
IMPORTANT: Always ensure the food proces-
sor is not connected to mains power before
assembling or disassembling parts.
1. Align the drive shaft with the mount on the
top of the base.
2. Push the drive shaft down into the mount on
the base.
3. Slot the bowl onto the base as shown.
Rotate the bowl clockwise until the raised sec-
tion on the base of the bowl is aligned with the
padlock symbol on the base.
The bowl is now locked on the base.
NOTE: The food processor will not function if
the bowl is not aligned properly with the lock
symbol.
To Next Page
Loading...