Technical data
7’’ screen 158x93mm,1024x600 dpi resolution
Capacitive touch screen
Quad-core ARM Cortex A9 CPU
1GB DDR3 SDRAM
Linux Embedded Operative System
Power Input: 12-24 VDC – 1,5 A Max
Power Consumption: 10 Watt
Direct connection to KNX TP bus
Operating Temperature: 0°C / + 50°C
Measurements
Caution
To reduce the risk of electric shock, this product should only be opened by an authorized technician
when service is required.
Risk of electric shock
Do not open
ENGLISH
Compliances
2006/95/CE
EN 60950-1
89/336/CE
Content
Envision 7 touch server
BUS and power terminal connector
Installation Sheet
Power Adapter 24 Vdc 30W (optional)
Frame (optional)
Installation
Envision Touch server must be installed in
compliance with electrical installation rules of your
country. The server must be installed in a dust
free place, not subject to water infiltration and
must not be placed near a source of heat or in
direct contact with the sun.
Do not direct connect to main AC power suply
Disclaimer
Not attending to these regulations and safety
instruction might cause fatal accidents, injuries,
and damages to persons and property.
The manufacturer / supplier assumes no liability
for damages caused by failure to comply with the
intended use.
To Next Page
Loading...