06
Step 8:Clean sprayer. After the project is completed, or when the sprayer has been left for more than 24
hours, you need to clean the sprayer completely to prevent the paint from drying out and clogging the air
holes and paint passages.Note: the motor part should not be wetted, please wipe it clean with a dry towel.
●
Disassemble the Spray gun unit.(Fig 10-1 & Fig 11)
● Put the excess paint in the canister into the paint bucket.
(Fig 10-2)
● Fill some water to clean the canister.
(Fig 10-3)
● Clean all parts of the spray gun(
Fig 12-1
), drip some anti-rust oil (
Fig 12-2
),and spray again with clean water
to completely remove the paint in the pipeline(
Fig 12-3
). Dry them and put them in the bag for storage.
30% overlap
30% overlap
"S" type spraying route
(Fig 9)
(Fig 10-1) (Fig 10-2) (Fig 10-3)
(Fig 11)
To Next Page
Loading...