GB
WiPro „all in one“ Operating Instructions Page 4
1.9.2 Sequence of a gas alarm
If an assigned wireless gas alarm sends out an alarm signal because
a critical gas concentration has been reached, or a gas alarm which
is connected to the gas alarm input gives an alarm, this will signal
an alarm whether the system is armed or not.
The siren sounds for about 30 seconds with short interruptions.
The interior beeper sounds for about 30 seconds with short interruptions.
Depending on the vehicle type, the horn also sounds for about 30 seconds.
Thevehicleindicatorsashforabout180seconds.
ThestatusLEDashesforabout180seconds.
If the cause of the alarm is not eliminated (critical gas concentration), the vehicle
indicatorsandthestatusLEDwillstarttoashagainuntilthegasconcentrationhas
reached a non-critical level.
1.9.3 Interrupting a burglary alarm with the remote key fob
The “unlock” button interrupts the alarm or disarms the system.
It may be necessary to close the cab doors,
depending on the vehicle type.
Thevehicleindicatorsashonceortwice(dependingonthevehicletype),
theinteriorbeepersoundstwiceandthestatusLEDstopsashing.
1.9.4 Interrupting a gas alarm with the remote key fob
The “unlock” button interrupts the alarm or disarms the system.
If the alarm is triggered with the system disarmed, the latter must be
armedrst(see1.1)inordertointerruptthealarmafterwardswith“unlock”.
It may be necessary to close the cab doors, depending on the vehicle type.
Thevehicleindicatorsashonceortwice(dependingonthevehicletype),
theinteriorbeepersoundstwiceandthestatusLEDstopsashing.
1.9.5 Interrupting a burglary alarm with the handheld transmitter
Any button interrupts the alarm or disarms the system.
It may be necessary to close the cab doors,
depending on the vehicle type.
Thevehicleindicatorsashtwice,theinteriorbeepersoundstwice
andthestatusLEDstopsashing.