Floor tom
1. Fasten the three oor tom spurs (8) to the tom (9) with the wing nuts of the fastening clamps and hand-tighten them.
2. Align the oor tom spurs (8) according to your needs and then tighten the wing nuts of the fastening clamps evenly.
Snare pad
1. Loosen the wing nut of the spurs of the snare stand (10), align it according to your needs and then tighten the wing nut
again.
2. Open the arms of the snare stand (11), place the snare pad (12) on the arms and then tighten the fastening clamp (13) to x
the snare pad in place.
Assembly
MPS-1000
9
To Next Page
