Press the [PATCH] button to activate the patch mode. At that, the middle point of the three-
digit LED display lights up.
After switching on the device is in patch mode.
1.
Turn the [DIAL/ENTER] control to select a suitable patch (001 … 200).
ð
The current ‘Patch number’ flashes in the LED display, but the sound is still
unchanged.
2. Now push on the [DIAL/ENTER] control to confirm the patch selection.
ð
Now the sound changes and the ‘Patch number’ stops flashing.
3. Press any other key to exit the patch mode.
Selecting a patch
The functions of the device
Synth Drum
15
To Next Page
Loading...
