thomann millenium - Loop Functions; Loop Selection and Volume Control

Press the [LOOP] button to activate the loop mode. At that, the left point of the three-digit LED
display lights up.
This unit offers you 100 built-in drum loops in total to choose from.
1.
Turn the [DIAL/ENTER], control to select a suitable loop (001 … 100).
ð
The current ‘Loop number’ flashes in the LED display, but the sound is still
unchanged.
2. Now push on the [DIAL/ENTER], control to confirm the loop selection.
ð
Now the sound changes and the ‘Loop number’ stops flashing.
3. Press the [LOOP] button again to proceed to the loop volume control mode (Display:
… ). Turn the [DIAL/ENTER] knob to select a suitable volume level.
Press the [LOOP] button again to toggle between both modes.
Press the [DIAL/ENTER] button to save the current setting.
Selecting a loop
The functions of the device
hand-drum pad
16