thomann Stairville PS 1500 DMX User Manual

PRODUCT DESCRIPTION:
GENERAL FUNCTIONS :
CAUTION:
Avoid direct eye exposure.
Disconnect from main power before replacing lamp or servicing unit.
Remember to always replace with same lamp.
To prevent fire or shock hazard, do not expose this unit to rain or moisture.
This product must not be used continuously longer than 15 minutes under
maximum speed and dimmer.
This model is a powerful DMX strobe that allows to control flash speed and dimmer.
It has two operating mode by changing dip switch setting: self-test mode and DMX
pack mode.
1.POWER INPUT: AC 120/230/240/250V 50/60Hz
2.CIRCUIT BREAKER: 16A
3.POWER INDICATOR: indicates when power is on.
4.DMX DIP SWITCH: Assign dip switch 10 to OFF, this unit is in DMX pack mode...
Assign dip switch 10 to ON, this unit is in self-test mode.
5.DMX INDICATOR: Indicates when DMX signal is available.
6.DMX SIGNAL OUTPUT: XLR female socket, use to connect other unit.
7.DMX SIGNAL INPUT: XLR male socket, use to receive DMX signals.
1. Please confirm power input is matched with that specified on this unit.
2. Plug in power cord to turn the power on.
3.this unit has two operating modes: self-test mode and DMX pack mode.
4. Switch dip switch 10 to ON position, this unit is in self-test mode.
5. Switch dip switch 10 to OFF position, this unit is in DMX pack mode. Follow DMX
address setting printed on the rear for desired flash speed and dimmer.
6. For safety, disconnect power cable when not using.
OPERATING INSTRUCTIONS:
DMX DIPSWITCH
DMX
POWER
ON
OFF
TESTADDRESS
INDICATCRINDICATCR
DMX INDMX OUT
DMX OUT
DMX IN
1=Ground
2=Data -
3=Data +
1
2
3
1
2
3
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
WARNING: SHOCK HAZARD-DO NOT OPEN
4 53
1
2
6 7
SWITCH
ON
OFF
user manual
PS 1500 DMX
english

thomann Stairville PS 1500 DMX Specifications

General

Brand	thomann
Model	Stairville PS 1500 DMX
Category	Lighting Equipment
Language	English

Summary

Product Description

General Functions Overview

Power Input

Specifies the AC power input voltage and frequency requirements for the unit.

Circuit Breaker

Details the circuit breaker rating, which is 16A.

Power Indicator

Indicates when the unit is powered on.

DMX DIP Switch

Assigns operating modes (DMX pack or self-test) via dip switch 10.

DMX Indicator

Shows when a DMX signal is actively received by the unit.

DMX Signal Output

An XLR female socket for connecting to other DMX units.

DMX Signal Input

An XLR male socket for receiving DMX signals.

Operating Instructions

Confirm Power Input Match

Verify that the connected power input matches the unit's specifications.

Power On Procedure

Plug in the power cord to activate the unit.

Operating Modes

Unit offers self-test mode and DMX pack mode, controlled by dip switch 10.

Self-Test Mode Setup

Set dip switch 10 to ON for self-test mode.

DMX Pack Mode Setup

Set dip switch 10 to OFF for DMX pack mode, follow rear settings.

Power Disconnection

Disconnect the power cable when the unit is not in use for safety.

Safety Precautions

General Safety Warnings

Includes warnings about eye exposure, servicing, lamp replacement, moisture, and continuous use.