The package includes a set of strings for the Hawaiian tuning (G - C - E - A). Tie a knot
at one end of the strings (simple knot for the two thicker strings, double knot for the
two thinner strings) and insert the strings into the grooves of the bridge as shown in
the figure:
n top position: G string (second thickest string)
n second position: C string (thickest string)
n third position: E string (second thinnest string)
n lowest position: A string (thinnest string)
Thread the loose ends of the four strings into the holes of the designated machine
heads. Make sure to attach each of the four strings with two to three turns securely to
the tuning pins (see figure). First, slightly pre-tighten all strings and check the action
as described in the following section.
Stringing the Ukulele
Assembly instructions
Ukulele
10
To Next Page
Loading...
