Cleaning the fresh water tank (only for spray extraction)
Remove the fresh water tank by lifting out of the appliance.
Take off the lid of the fresh water tank by pulling it up and empty the
tank of any remaining water.
Clean the fresh water tank and its lid with clean, warm water to remove
any cleaning agent residue, which may be corrosive.
Put the lid back on the fresh water tank.
Lower the fresh water tank into the rear of the appliance.
If the suction filter was removed, place it back in the waste water
tank.
Only for wet vacuuming and spray extraction: If the spray extraction
insert was removed, lower it into the waste water tank. Make sure
that the float switch can move freely.
Insert the two foam filters. Close the two parts of the aqua filter lid
until you see and hear them latch into place.
Close the aqua filter.
To do this, place the aqua fi lter lid in the two holders on the waste
water tank and gently push the aqua fi lter down until you hear the
unlocking tab latch into place.
If heavily soiled, you can remove the ejector for cleaning by turning
the port gasket.
Rinse the ejector with warm water.
Temiz su tankının temizlenmesi (sadece yıkamada)
Temiz su tankını yukarıdan cihazdan çıkartın.
Temiz su tankının kapaını yukarıdan çıkartın ve içeride su kalmısa, bu
suyu boaltın.
Temiz su tankını ve kapaını temiz, gereinde sıcak, su ile yıkayın ve
içinde bulunabilecek olan agresif temizlik maddesi artıklarını temizleyin.
Temiz su tankının kapaını temiz su tankına takın.
Temiz su tankını yukarıdan cihazın arkasına yerletirin.
Temizlik
Vakum filtresi çıkartıldı ise, yeniden pis su kabına yerletirin.
Sadece ya temizlemede ve yıkamada: Yıkama vakum parçası
çıkartıldı ise, yeniden pis su kabına yerletirin. amandıralı seviye
alterinin serbest hareket edebildiini kontrol edin.
Her iki suni köpük filtresini takın. Su filtresi kapaının her iki parça-
sını yerine oturdukları görülene ve duyulana kadar kapatın.
Su filtresini kapatın.
Bunun için su fi ltresi kapaını pis su kabındaki iki yuvaya yerletirin
ve su fi ltresini, kilit açma mandalını hafi fçe bastırdıktan sonra, yerine
oturduu duyulana kadar döndürün.
Çok fazla kirlenmi ise, ejektör, temizlik ilemi için balantı azı
contası döndürülerek çıkartılabilir.
Ejektörü sıcak su ile yıkayın.