Why is the suction power of my Thomas Vacuum Cleaner gradually decreasing?
The suction power may be decreasing because the special hygiene filter is clogged and needs cleaning. Alternatively, the nozzles, suction pipe, or hoses might be blocked by dirt; try stretching the hose during operation to loosen the blockage or remove it completely. Also, ensure that the housing cover is properly shut.
How to fix insufficient suction power on Thomas Vacuum Cleaner?
Insufficient suction power can occur if the ejector in the suction port is clogged; disassemble and clean it, or rinse it with water. Also, check if the special hygiene filter is clogged and clean it if necessary. Ensure nozzles, suction pipe, or hoses are free of blockages by disassembling and cleaning them. Verify that the electronic suction power control isn't set to MIN; if it is, set it to MAX. Finally, make sure the mechanical suction power control on the handle is closed by closing the sliding button.
What to do if my Thomas Vacuum Cleaner will not start?
Check if the power cord, plug, and socket are intact. Unplug the power cord before checking. Repairs should be carried out by authorized specialists. Also, verify that the appliance is switched on.
Why is no cleaning fluid coming out of my Thomas XT even though the pump is on?
First, check if there is cleaning fluid in the spray solution tank and top it up if necessary. If the tank is full, the spray nozzle might be clogged; place it in lukewarm water for a while and then blow it out. Finally, the tank connection duct could be clogged; remove the fresh water tank and use the crevice nozzle to thoroughly vacuum any dirt from the tank connection duct (between the fresh water tank and the housing).
Why does my Thomas XT switch off during operation?
The appliance might be switching off because the waste water tank is full; empty it. Alternatively, the appliance may have been tilted or suddenly turned, triggering the float switch. Place the appliance in a level position and switch it on again.
Why is dust coming out of my Thomas XT during vacuuming?
Dust may come out of the appliance during vacuuming if the aqua filter system isn't fitted as described in the user manual or if there is not enough water in the waste water tank. Check both of these items.
What to do if an excessive pool of water collects in the suction chamber of my Thomas XT?
If you notice a large amount of water in the suction chamber, it could be due to dirty gaskets and seal faces; clean them. It's also possible that the spray extraction insert was forgotten; check if it is properly installed.
Why is water coming out of the exhaust openings of my Thomas XT Vacuum Cleaner?
Water may come out of the exhaust openings if the float in the waste water tank is dirty and stuck, preventing it from responding when the tank is full. Clean the float and the tank.
Why is there excessive foaming in the waste water tank of my Thomas XT Vacuum Cleaner?
Excessive foaming in the waste water tank may be caused by not using genuine THOMAS cleaning concentrate. Replace it with the recommended cleaner.
Essential safety guidelines for operating the appliance safely.
Specific safety precautions for spray extraction and wet vacuuming modes.
Instructions for performing wet vacuum cleaning and spray extraction.
Detailed instructions for operating the spray extraction function of the vacuum cleaner.
General cleaning instructions for the appliance and its components.
Procedures for cleaning the aqua filter under various soiling conditions.
Addresses issues related to the appliance not starting or general malfunctions.
General| Brand | Thomas |
|---|---|
| Model | XT |
| Category | Vacuum Cleaner |
| Language | English |
To Next Page