THOMSON 513628 - Configuration; Quick Start-Up; Pairing the Sensor; Time and Date Setting

WIRELESS WEATHER STATION
EN
8
www.thomsonsecurity.eu
C - CONFIGURATION
1 - QUICK START-UP
These steps must be followed in order.
Insert 2 AA LR06 batteries (not supplied) into the
station 15. Then insert the 2 AAA LR03 batteries (not
supplied) into the outdoor sensor, ensuring that the
polarity is respected 16.
PAIRING THE SENSOR TO THE STATION
Pairing is automatic once the batteries are inserted.
To force pairing, if required:
- On the station, press and hold the button for 5
seconds DOWN, the indicator
starts blinking
- On the outdoor sensor, remove then reinsert the
batteries, positioning yourself near the weather
station
TIME AND DATE SETTING
- Hold the SET button until the "°C" starts ashing.
- Set the measurement unit choice using the + and
- buttons (°C = Celsius or °F = Fahrenheit).
Conrm using the SET key.
- 24h or 12h ashes on the screen. Set the time
display format using the + and - buttons.
Conrm using the SET key.
- Both digits: 00 ashes on the screen: set the time
zone using the UP and DOWN buttons.
Conrm using the SET key.
- Then set the hour using the + and - buttons.
Conrm using the SET key.
- Set the minutes using the + and - buttons.
Then conrm using the SET key.
ALARM SETTING
- Press the SET button once: the letters AL appear
on the hour side.
- Press and hold the SET button for 3 seconds: The
hour of the alarm ashes on the screen.
Set the hour of the alarm using the + and - buttons
- Press the SET button to conrm. The minutes ash
on the screen.
- Set the minutes of the alarm using the + and -
buttons
- Press the SET button to conrm. Zz 05 ashes on
the screen.
- Set the alarm snooze duration using the + and -
buttons
- Finish the conguration by pressing quickly on the
SET button
- When the alarm goes off, pressing the Snooze/
Light button cuts off the alarm and postpones it
to the pre-set time (Zz).
To set the alarm, press once on the + button: a bell
icon
(3) appears between the hour and the
minutes.
To turn off the alarm, press the + button once: the
bell (3) disappears.
The tone lasts for a maximum of 2 minutes.
AUTOMATIC TIME SETTING
To launch the automatic time setting for the station,
press and hold the + button until the LED ashes
(4). The station switches to radio reception (for 7
minutes) and attempts to pick up the DCF77 time
signal to automatically update the time and date.
Note: the time zone must be set correctly for a
correct display. If reception is insufcient, please set
the station near a window.
Ensure that you leave a gap of 2.5 m between the
station and any source of interference (television,
router, microwaves, etc.)
The signal search can be cut off at any point by
pressing the + button, if the signal is not available.
MIN - MAX VALUE DISPLAY
- Quickly pressing on MEM displays the maximum
values measured; pressing MEM again displays
the minimum values.
A third press on MEM returns to the current value
display. Pressing and holding for 3 seconds on
MEM erases the MIN/MAX values saved.