THOMSON SB200BT - Page 18

- EN 18 -
• No audio from a connected device for 10 minutes.
It can be switched ON by using the POWER selector again.
Use
Play from external audio
You can play from an external audio device such as MP3 player through this unit.
A. Optical in Jack (Requires an optical cable)
1. Connect an Optical cable to the optical jack on back panel. Connect the other end of the
Optical cable to the digital audio device.
2. Press the button to turn the unit on.
3. Press the SOURCE button to switch to Optical In mode.
4. Use the controls on the connected device to begin playing audio routed through the unit.
B. Line in Jack (Requires a 3.5mm cable)
1. Connect a 3.5mm cable to the Line jack on top panel. Connect the other end of the
3.5mm cable to an Mp3 player or other audio device.
2. Press the button to turn the unit on.
3. Press the SOURCE button to switch to Line In mode.
4. Use the controls on the connected device to begin playing audio routed through the unit.
C. Auxiliary Input RCA (Requires an RCA cable)
1. Connect an RCA cable to the Auxiliary Input. Connect the other end of the RCA cable to
the audio output on your DVD player, 󰘵ereo sy󰘵em, gaming sy󰘵em or television.
2. Press the power button to turn the unit on.
3. Press the SOURCE button to switch to Aux In mode.
4. Use the controls on the connected device to begin playing audio routed through the unit.
D. Using the USB input
1. Plug your USB 󰘱ash drive to the USB socket.
2. Press SOURCE button to select USB mode, the unit can play automatically.
3. Press the / to select track.
4. Press the VOL+/VOL- to adju󰘵 the volume.
Remarks: USB port is easy to sensitive equipment, will cause the equipment work is not
󰘵able.
Bluetooth Mode
A. Pairing with a Bluetooth cell phone
Please make sure your cell phone is Bluetooth-enabled. Speci󰘰c pairing 󰘵eps may vary with
di󰘯erent cell phones. Please refer to the user manual of your cell phone for further information.
The general pairing 󰘵eps are as follows :
1. Keep SB100BT/SB200BT and Bluetooth cell phone within 1 meter when pairing.
2. Press , button, and press the SOURCE to select the Bluetooth mode.
3. Switch on your cell phone’s Bluetooth function and search for Bluetooth devices. After the
search is completed, select “SB100BT/SB200BT from the Bluetooth device li󰘵.
4. According to indication, enter password or PIN No: “0000” and press “Yes” or “con󰘰rm”.
5. After successful pairing, select “SB100BT/SB200BT” from the Bluetooth device li󰘵 and
press “connect”.